PenangAPRS Track

My position About ☰

reset

YC2SNK-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object YC2SNK-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1794356354	23 Count	338 Count
1794354550	22 Count	316 Count
1794352746	21 Count	299 Count
1794351640	20 Count	299 Count
1794350545	19 Count	299 Count
1794339073	18 Count	299 Count
1794337269	17 Count	270 Count
1794335465	16 Count	251 Count
1794333661	15 Count	227 Count
1794331907	14 Count	208 Count
1794330103	13 Count	190 Count
1794328299	12 Count	175 Count
1794326495	11 Count	166 Count
1794324691	10 Count	153 Count
1794322887	9 Count	139 Count
1794321083	8 Count	124 Count
1794319279	7 Count	111 Count
1794317474	6 Count	98 Count
1794315670	5 Count	84 Count
1794313865	4 Count	69 Count
1794312061	3 Count	56 Count
1794310304	2 Count	43 Count
1794308500	1 Count	30 Count
1794306696	0 Count	15 Count
1794304893	81 Count	1009 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)