PenangAPRS Track

My position About ☰

reset

F6DAY-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object F6DAY-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1786403804	287 Count	328 Count	256 Count
1786402840	284 Count	324 Count	254 Count
1786401876	279 Count	317 Count	250 Count
1786400911	260 Count	290 Count	232 Count
1786399948	257 Count	284 Count	230 Count
1786398983	254 Count	280 Count	228 Count
1786398020	251 Count	275 Count	226 Count
1786397055	246 Count	269 Count	222 Count
1786396091	243 Count	262 Count	220 Count
1786395127	238 Count	256 Count	216 Count
1786394163	234 Count	249 Count	213 Count
1786393199	230 Count	245 Count	210 Count
1786392811	227 Count	242 Count	208 Count
1786391846	223 Count	238 Count	205 Count
1786390883	218 Count	233 Count	201 Count
1786389918	211 Count	223 Count	195 Count
1786388954	207 Count	218 Count	192 Count
1786387990	205 Count	215 Count	191 Count
1786387026	202 Count	212 Count	189 Count
1786386062	199 Count	209 Count	187 Count
1786385098	196 Count	206 Count	185 Count
1786384134	179 Count	188 Count	169 Count
1786383168	136 Count	146 Count	127 Count
1786382204	112 Count	122 Count	104 Count
1786381240	80 Count	90 Count	73 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)