PenangAPRS Track

My position About ☰

reset

HB9IMG Telemetry

This is the latest recevied telemetry packets stored in our database for station/object HB9IMG. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1786429122	486 Count	282 Count	277 Count
1786427319	485 Count	282 Count	277 Count
1786425516	484 Count	282 Count	277 Count
1786423712	483 Count	282 Count	277 Count
1786421909	482 Count	282 Count	277 Count
1786420105	481 Count	282 Count	277 Count
1786418302	480 Count	282 Count	277 Count
1786416499	479 Count	282 Count	277 Count
1786414695	478 Count	282 Count	277 Count
1786412892	475 Count	280 Count	275 Count
1786411126	467 Count	277 Count	272 Count
1786409322	464 Count	275 Count	270 Count
1786407519	460 Count	272 Count	267 Count
1786405716	456 Count	269 Count	264 Count
1786403912	452 Count	266 Count	261 Count
1786402109	449 Count	264 Count	259 Count
1786400305	443 Count	259 Count	254 Count
1786398502	441 Count	258 Count	253 Count
1786396699	436 Count	254 Count	249 Count
1786391289	425 Count	246 Count	241 Count
1786389523	419 Count	245 Count	240 Count
1786387719	414 Count	241 Count	236 Count
1786385916	409 Count	237 Count	232 Count
1786384113	404 Count	233 Count	228 Count
1786380506	397 Count	228 Count	223 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)