PenangAPRS Track

My position About ☰

reset

SQ9PL-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ9PL-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1780192249	122 Count	441 Count	101 Count
1780190449	114 Count	414 Count	94 Count
1780188656	102 Count	393 Count	87 Count
1780186855	93 Count	363 Count	79 Count
1780185054	85 Count	339 Count	72 Count
1780183254	78 Count	307 Count	66 Count
1780181453	70 Count	269 Count	59 Count
1780179652	62 Count	241 Count	52 Count
1780177852	54 Count	211 Count	45 Count
1780176051	44 Count	174 Count	36 Count
1780174250	37 Count	143 Count	30 Count
1780172449	26 Count	98 Count	20 Count
1780170648	19 Count	68 Count	14 Count
1780168848	11 Count	34 Count	7 Count
1780167055	244 Count	1038 Count	203 Count
1780165254	232 Count	996 Count	192 Count
1780163453	224 Count	956 Count	185 Count
1780161652	219 Count	919 Count	181 Count
1780158051	204 Count	858 Count	171 Count
1780156250	192 Count	836 Count	163 Count
1780154449	182 Count	809 Count	155 Count
1780152649	171 Count	766 Count	147 Count
1780150848	159 Count	716 Count	136 Count
1780147247	148 Count	640 Count	127 Count
1780145454	140 Count	585 Count	124 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)