PenangAPRS Track

My position About ☰

reset

SR8MBR-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SR8MBR-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1790342376	633 Count	1032 Count
1790340575	599 Count	991 Count
1790338774	516 Count	831 Count
1790336974	469 Count	772 Count
1790335173	426 Count	715 Count
1790333373	385 Count	656 Count
1790331572	340 Count	592 Count
1790329771	250 Count	409 Count
1790327971	141 Count	245 Count
1790326170	58 Count	79 Count
1790324369	3 Count	0 Count
1790322576	769 Count	987 Count
1790320775	733 Count	957 Count
1790318974	699 Count	921 Count
1790317174	628 Count	798 Count
1790315373	588 Count	740 Count
1790313572	560 Count	711 Count
1790311772	531 Count	682 Count
1790309971	497 Count	647 Count
1790308170	469 Count	613 Count
1790306370	438 Count	568 Count
1790304569	395 Count	491 Count
1790302768	320 Count	324 Count
1790300975	285 Count	291 Count
1790299174	250 Count	254 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)