PenangAPRS Track

My position About ☰

reset

EA4IAX-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object EA4IAX-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

Time	TX*	RX*
1792731285	264 Count	891 Count
1792727724	259 Count	827 Count
1792724121	254 Count	725 Count
1792720518	249 Count	654 Count
1792716915	244 Count	610 Count
1792713312	238 Count	546 Count
1792709709	233 Count	479 Count
1792706106	227 Count	443 Count
1792702502	222 Count	402 Count
1792698900	216 Count	360 Count
1792695296	211 Count	310 Count
1792691694	126 Count	259 Count
1792688090	2 Count	189 Count
1792684522	1 Count	127 Count
1792680920	0 Count	73 Count
1792677317	88 Count	1030 Count
1792673711	87 Count	969 Count
1792670108	80 Count	914 Count
1792666505	75 Count	848 Count
1792662901	69 Count	785 Count
1792659298	64 Count	732 Count
1792655695	59 Count	683 Count
1792652092	55 Count	614 Count
1792648489	49 Count	563 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)