PenangAPRS Track

My position About ☰

reset

F4JTC-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object F4JTC-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1771516900	751 Count	765 Count	509 Count
1771516596	749 Count	762 Count	508 Count
1771516293	746 Count	757 Count	506 Count
1771515986	744 Count	755 Count	505 Count
1771515379	737 Count	745 Count	500 Count
1771515076	735 Count	742 Count	499 Count
1771514772	731 Count	737 Count	496 Count
1771514469	728 Count	735 Count	494 Count
1771513862	725 Count	731 Count	493 Count
1771513559	723 Count	729 Count	492 Count
1771513256	720 Count	726 Count	490 Count
1771512345	714 Count	720 Count	487 Count
1771512042	712 Count	719 Count	486 Count
1771511739	711 Count	718 Count	486 Count
1771511132	706 Count	712 Count	483 Count
1771510828	703 Count	710 Count	481 Count
1771510525	702 Count	709 Count	481 Count
1771510222	698 Count	705 Count	478 Count
1771509918	689 Count	696 Count	470 Count
1771509615	676 Count	682 Count	458 Count
1771509312	668 Count	674 Count	451 Count
1771509008	665 Count	671 Count	449 Count
1771508401	652 Count	660 Count	438 Count
1771508098	643 Count	652 Count	430 Count
1771507795	638 Count	647 Count	426 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)