PenangAPRS Track

My position About ☰

reset

SP2KDS-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP2KDS-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1780188744	22 Count	376 Count	4 Count
1780186944	21 Count	358 Count	4 Count
1780185143	20 Count	332 Count	4 Count
1780183343	19 Count	309 Count	4 Count
1780181542	18 Count	286 Count	4 Count
1780179741	17 Count	259 Count	4 Count
1780177947	12 Count	233 Count	4 Count
1780176146	11 Count	214 Count	4 Count
1780174346	10 Count	191 Count	4 Count
1780172545	9 Count	169 Count	4 Count
1780170745	8 Count	145 Count	4 Count
1780168944	7 Count	126 Count	4 Count
1780167143	6 Count	103 Count	4 Count
1780165343	5 Count	83 Count	4 Count
1780163542	4 Count	56 Count	4 Count
1780161742	54 Count	1017 Count	13 Count
1780159941	53 Count	994 Count	13 Count
1780158140	52 Count	969 Count	13 Count
1780156346	47 Count	910 Count	13 Count
1780154546	46 Count	889 Count	13 Count
1780152745	45 Count	855 Count	13 Count
1780150944	44 Count	831 Count	13 Count
1780149144	43 Count	801 Count	13 Count
1780147343	42 Count	772 Count	13 Count
1780145542	41 Count	738 Count	13 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)