PenangAPRS Track

My position About ☰

reset

SQ4VW-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ4VW-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1794364002	404 Count	792 Count	202 Count
1794363701	402 Count	791 Count	202 Count
1794363401	399 Count	782 Count	200 Count
1794363100	396 Count	778 Count	199 Count
1794362799	394 Count	768 Count	198 Count
1794362499	391 Count	764 Count	197 Count
1794362198	388 Count	755 Count	195 Count
1794361897	386 Count	753 Count	195 Count
1794361596	383 Count	744 Count	193 Count
1794361295	380 Count	740 Count	192 Count
1794360995	378 Count	731 Count	191 Count
1794360694	375 Count	724 Count	190 Count
1794360393	372 Count	716 Count	188 Count
1794360092	370 Count	715 Count	188 Count
1794359791	367 Count	705 Count	186 Count
1794359490	364 Count	699 Count	185 Count
1794359190	362 Count	689 Count	184 Count
1794358889	359 Count	684 Count	183 Count
1794358588	356 Count	676 Count	181 Count
1794358287	354 Count	674 Count	181 Count
1794357987	351 Count	664 Count	179 Count
1794357686	348 Count	659 Count	178 Count
1794357385	346 Count	650 Count	177 Count
1794357084	343 Count	645 Count	176 Count
1794356784	340 Count	635 Count	174 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)