PenangAPRS Track

My position About ☰

reset

SP4WSL-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP4WSL-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1790298350	677 Count	862 Count	647 Count
1790296549	656 Count	837 Count	627 Count
1790294748	635 Count	812 Count	607 Count
1790292948	614 Count	787 Count	587 Count
1790291147	593 Count	763 Count	567 Count
1790289347	568 Count	734 Count	543 Count
1790287546	551 Count	709 Count	527 Count
1790285745	530 Count	684 Count	507 Count
1790283945	512 Count	660 Count	490 Count
1790282144	492 Count	636 Count	471 Count
1790280343	472 Count	611 Count	452 Count
1790278543	431 Count	562 Count	412 Count
1790276752	386 Count	506 Count	368 Count
1790274952	368 Count	482 Count	351 Count
1790273151	350 Count	459 Count	334 Count
1790271350	331 Count	433 Count	316 Count
1790269550	314 Count	408 Count	300 Count
1790267749	295 Count	382 Count	282 Count
1790265948	278 Count	360 Count	266 Count
1790264148	258 Count	337 Count	247 Count
1790262347	239 Count	312 Count	229 Count
1790260545	218 Count	286 Count	209 Count
1790258743	197 Count	259 Count	189 Count
1790256942	175 Count	229 Count	168 Count
1790255148	148 Count	194 Count	142 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)