PenangAPRS Track

My position About ☰

reset

SP5UID-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP5UID-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1781908507	17 Count	179 Count
1781906705	16 Count	177 Count
1781904904	15 Count	175 Count
1781903102	14 Count	174 Count
1781901306	13 Count	172 Count
1781899504	12 Count	171 Count
1781897703	11 Count	169 Count
1781895902	10 Count	168 Count
1781894106	9 Count	133 Count
1781892304	8 Count	121 Count
1781890503	7 Count	117 Count
1781888701	6 Count	115 Count
1781886906	5 Count	104 Count
1781885104	4 Count	86 Count
1781883303	3 Count	76 Count
1781881501	2 Count	68 Count
1781879705	1 Count	64 Count
1781877903	0 Count	53 Count
1781876102	39 Count	1016 Count
1781874301	38 Count	923 Count
1781872506	37 Count	875 Count
1781870704	36 Count	840 Count
1781868903	35 Count	770 Count
1781867101	29 Count	755 Count
1781865305	28 Count	729 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)