PenangAPRS Track

My position About ☰

reset

W4KEL-7 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object W4KEL-7. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	Value1*	Value2*
1769807986	13.39	10.96
1769805947	13.45	11.45
1769803908	13.48	11.45
1769801869	13.42	11.45
1769799829	13.45	10.47
1769797790	13.42	10.47
1769795750	13.48	9.98
1769793711	13.45	10.96
1769791671	13.45	10.96
1769789632	13.48	11.45
1769787592	13.45	11.45
1769785553	13.42	11.45
1769783514	13.48	10.47
1769781475	13.42	10.47
1769779436	13.45	10.47
1769777397	13.42	10.47
1769775357	13.42	10.47
1769773318	13.48	10.47
1769771278	13.42	10.47
1769769239	13.45	10.47
1769767199	13.42	10.47
1769765159	13.45	10.47
1769763120	13.42	10.47
1769761080	13.42	10.47
1769759041	13.42	10.47

*Used Equation Coefficients:

Value1: 0, 0.0293, 0

Value2: 0, 0.489, -273.15

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)