PenangAPRS Track

My position About ☰

reset

SQ2MO Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ2MO. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1790325543	173 Count	658 Count	50 Count
1790324943	172 Count	654 Count	50 Count
1790324342	171 Count	649 Count	50 Count
1790323140	168 Count	640 Count	49 Count
1790322539	167 Count	636 Count	49 Count
1790321939	165 Count	631 Count	48 Count
1790321338	164 Count	628 Count	48 Count
1790320737	163 Count	624 Count	48 Count
1790320136	161 Count	619 Count	47 Count
1790319536	160 Count	615 Count	47 Count
1790318935	159 Count	612 Count	47 Count
1790318334	157 Count	608 Count	46 Count
1790317733	156 Count	605 Count	46 Count
1790317132	155 Count	600 Count	46 Count
1790316532	153 Count	595 Count	45 Count
1790315931	152 Count	592 Count	45 Count
1790315331	149 Count	585 Count	43 Count
1790314730	147 Count	579 Count	42 Count
1790314129	146 Count	574 Count	42 Count
1790313529	145 Count	570 Count	42 Count
1790312927	143 Count	565 Count	41 Count
1790312326	142 Count	562 Count	41 Count
1790311726	141 Count	558 Count	41 Count
1790311125	139 Count	553 Count	40 Count
1790310524	138 Count	551 Count	40 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)