PenangAPRS Track

My position About ☰

reset

SP2ROC-14 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP2ROC-14. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1786412040	62 Count	197 Count	50 Count
1786411439	60 Count	188 Count	49 Count
1786410839	52 Count	166 Count	42 Count
1786410238	48 Count	155 Count	39 Count
1786409637	44 Count	141 Count	36 Count
1786409037	37 Count	119 Count	30 Count
1786408436	31 Count	105 Count	25 Count
1786407835	30 Count	97 Count	25 Count
1786407235	21 Count	70 Count	17 Count
1786406034	14 Count	48 Count	12 Count
1786405433	6 Count	22 Count	5 Count
1786404232	287 Count	1008 Count	218 Count
1786400240	277 Count	989 Count	214 Count
1786399638	274 Count	979 Count	212 Count
1786399037	267 Count	957 Count	206 Count
1786398437	259 Count	937 Count	199 Count
1786397836	253 Count	919 Count	194 Count
1786397235	247 Count	899 Count	189 Count
1786396635	238 Count	877 Count	181 Count
1786396034	231 Count	856 Count	175 Count
1786395433	229 Count	845 Count	174 Count
1786394833	218 Count	805 Count	164 Count
1786394232	209 Count	777 Count	156 Count
1786393632	207 Count	765 Count	155 Count
1786392430	197 Count	733 Count	147 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)