PenangAPRS Track

My position About ☰

reset

SP2HCA-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP2HCA-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 >>

Time	TX*	RX*	Digi*
1773727950	40 Count	436 Count	23 Count
1773726451	38 Count	405 Count	22 Count
1773724951	35 Count	377 Count	20 Count
1773723450	32 Count	342 Count	18 Count
1773721949	29 Count	299 Count	16 Count
1773718948	24 Count	231 Count	13 Count
1773717445	21 Count	203 Count	11 Count
1773715946	18 Count	174 Count	9 Count
1773713855	9 Count	121 Count	6 Count
1773712352	7 Count	74 Count	5 Count
1773710851	4 Count	53 Count	3 Count
1773709352	1 Count	30 Count	1 Count
1773707851	93 Count	1022 Count	49 Count
1773706349	90 Count	991 Count	47 Count
1773704850	87 Count	965 Count	45 Count
1773703349	84 Count	941 Count	43 Count
1773701849	82 Count	914 Count	42 Count
1773700346	80 Count	887 Count	41 Count
1773698847	78 Count	857 Count	40 Count
1773697347	76 Count	836 Count	39 Count
1773695844	73 Count	816 Count	37 Count
1773692253	63 Count	745 Count	34 Count
1773690751	61 Count	715 Count	33 Count
1773689252	58 Count	692 Count	31 Count
1773687751	56 Count	663 Count	30 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)