PenangAPRS Track

My position About ☰

reset

SP2OSA-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP2OSA-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1794334845	780 Count	82 Count	60 Count
1794333943	779 Count	82 Count	60 Count
1794333043	778 Count	82 Count	60 Count
1794332142	777 Count	82 Count	60 Count
1794331241	776 Count	82 Count	60 Count
1794330340	775 Count	82 Count	60 Count
1794329439	774 Count	82 Count	60 Count
1794328538	773 Count	82 Count	60 Count
1794327637	772 Count	82 Count	60 Count
1794326736	771 Count	82 Count	60 Count
1794325836	770 Count	82 Count	60 Count
1794324935	769 Count	82 Count	60 Count
1794324034	768 Count	82 Count	60 Count
1794323133	767 Count	82 Count	60 Count
1794322232	766 Count	82 Count	60 Count
1794321331	765 Count	82 Count	60 Count
1794320430	764 Count	82 Count	60 Count
1794319529	763 Count	82 Count	60 Count
1794318629	762 Count	82 Count	60 Count
1794317728	761 Count	82 Count	60 Count
1794316827	760 Count	82 Count	60 Count
1794315926	759 Count	82 Count	60 Count
1794315048	758 Count	82 Count	60 Count
1794314147	757 Count	82 Count	60 Count
1794313246	756 Count	82 Count	60 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)