PenangAPRS Track

My position About ☰

reset

SQ5CZL-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ5CZL-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1786430067	114 Count	76 Count	61 Count
1786429165	112 Count	74 Count	60 Count
1786428294	111 Count	74 Count	60 Count
1786427392	108 Count	70 Count	58 Count
1786426491	107 Count	69 Count	58 Count
1786425590	106 Count	68 Count	58 Count
1786424689	105 Count	68 Count	58 Count
1786423787	104 Count	68 Count	58 Count
1786422886	103 Count	68 Count	58 Count
1786421985	102 Count	68 Count	58 Count
1786421083	101 Count	68 Count	58 Count
1786420182	95 Count	63 Count	53 Count
1786419281	93 Count	62 Count	52 Count
1786418379	91 Count	61 Count	51 Count
1786417478	89 Count	60 Count	50 Count
1786416577	87 Count	59 Count	49 Count
1786415676	85 Count	58 Count	48 Count
1786414774	83 Count	57 Count	47 Count
1786413873	81 Count	56 Count	46 Count
1786412972	79 Count	55 Count	45 Count
1786412071	77 Count	54 Count	44 Count
1786411169	75 Count	53 Count	43 Count
1786410268	73 Count	52 Count	42 Count
1786409367	71 Count	51 Count	41 Count
1786408466	69 Count	50 Count	40 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)