PenangAPRS Track

My position About ☰

reset

SP3KON-11 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP3KON-11. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1773763948	5 Count	16 Count	2 Count
1773763047	426 Count	1012 Count	105 Count
1773762146	415 Count	987 Count	103 Count
1773761245	399 Count	957 Count	100 Count
1773760364	391 Count	940 Count	98 Count
1773759464	380 Count	911 Count	95 Count
1773758563	376 Count	898 Count	93 Count
1773757662	371 Count	883 Count	90 Count
1773756761	366 Count	869 Count	87 Count
1773755860	361 Count	851 Count	85 Count
1773754958	356 Count	837 Count	82 Count
1773754057	343 Count	809 Count	80 Count
1773753157	335 Count	790 Count	77 Count
1773752255	324 Count	767 Count	75 Count
1773751354	319 Count	753 Count	72 Count
1773750454	309 Count	728 Count	70 Count
1773749553	303 Count	713 Count	67 Count
1773748652	293 Count	690 Count	64 Count
1773747751	280 Count	661 Count	62 Count
1773746850	269 Count	636 Count	59 Count
1773745949	258 Count	614 Count	57 Count
1773745048	250 Count	592 Count	54 Count
1773744147	242 Count	571 Count	52 Count
1773743246	237 Count	553 Count	50 Count
1773742345	230 Count	538 Count	48 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)