PenangAPRS Track

My position About ☰

reset

W4KEL-9 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object W4KEL-9. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	Value1*	Value2*
1780070510	14.84	22.57
1780070505	14.78	22.57
1780070495	13.22	22.57
1780070466	13.19	22.09
1780070443	13.62	22.57
1780070300	13.16	22.09
1780070217	14.75	21.61
1780070204	13.16	22.09
1780070186	13.46	21.61
1780070141	13.19	21.61
1780070075	13.16	21.61
1780070031	13.16	21.61
1780070000	12.97	21.61
1780069984	13.16	21.61
1780069971	13.19	21.12
1780069875	13.19	21.12
1780069846	13.04	21.12
1780069779	13.16	21.12
1780069736	14.75	20.64
1780069666	13.16	20.64
1780069628	13.19	20.64
1780069559	13.19	20.15
1780069513	13.16	20.15
1780069351	14.69	19.67
1780069308	14.75	19.19

*Used Equation Coefficients:

Value1: 0, 0.0306, 0

Value2: 0, 0.484, -273.15

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)