PenangAPRS Track

My position About ☰

reset

SP2HCA-14 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP2HCA-14. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 >>

Time	TX*	RX*	Digi*
1770099047	472 Count	711 Count	327 Count
1770097254	463 Count	697 Count	323 Count
1770095453	457 Count	688 Count	318 Count
1770093653	452 Count	682 Count	314 Count
1770091852	445 Count	673 Count	308 Count
1770090051	440 Count	665 Count	304 Count
1770088251	435 Count	656 Count	300 Count
1770086450	430 Count	647 Count	296 Count
1770084649	425 Count	639 Count	292 Count
1770082848	420 Count	631 Count	288 Count
1770081048	415 Count	619 Count	284 Count
1770079247	410 Count	611 Count	280 Count
1770077446	405 Count	605 Count	276 Count
1770075653	396 Count	596 Count	272 Count
1770073852	391 Count	588 Count	268 Count
1770072051	386 Count	580 Count	264 Count
1770070251	378 Count	571 Count	257 Count
1770068450	373 Count	563 Count	253 Count
1770066649	368 Count	557 Count	249 Count
1770064849	363 Count	552 Count	245 Count
1770063048	358 Count	546 Count	241 Count
1770061247	353 Count	540 Count	237 Count
1770059446	348 Count	535 Count	233 Count
1770057646	343 Count	529 Count	229 Count
1770055845	338 Count	523 Count	225 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)