PenangAPRS Track

My position About ☰

reset

SR2CA-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SR2CA-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1769802293	12 Count	96 Count	6 Count
1769800611	8 Count	68 Count	4 Count
1769799187	2 Count	38 Count	2 Count
1769795825	97 Count	985 Count	63 Count
1769794144	94 Count	949 Count	61 Count
1769792463	91 Count	911 Count	59 Count
1769790782	88 Count	872 Count	57 Count
1769789101	85 Count	829 Count	55 Count
1769787419	82 Count	780 Count	53 Count
1769784058	76 Count	728 Count	49 Count
1769782377	75 Count	705 Count	49 Count
1769780696	72 Count	672 Count	47 Count
1769777573	62 Count	619 Count	43 Count
1769775892	59 Count	576 Count	41 Count
1769774211	57 Count	522 Count	40 Count
1769772530	54 Count	483 Count	38 Count
1769770850	51 Count	428 Count	36 Count
1769769168	48 Count	400 Count	34 Count
1769767487	43 Count	351 Count	30 Count
1769765807	28 Count	291 Count	16 Count
1769764126	26 Count	264 Count	15 Count
1769762445	23 Count	234 Count	13 Count
1769760764	20 Count	196 Count	11 Count
1769759083	17 Count	162 Count	9 Count
1769755983	7 Count	107 Count	5 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)