PenangAPRS Track

My position About ☰

reset

EA5SW-12 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object EA5SW-12. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1769802551	10 Count	79 Count
1769799910	9 Count	79 Count
1769799435	8 Count	79 Count
1769796794	7 Count	79 Count
1769794153	6 Count	79 Count
1769791513	5 Count	79 Count
1769788872	4 Count	79 Count
1769786232	3 Count	75 Count
1769783591	2 Count	39 Count
1769780951	1 Count	31 Count
1769778310	0 Count	0 Count
1769777840	44 Count	992 Count
1769775200	43 Count	928 Count
1769772559	42 Count	898 Count
1769769918	41 Count	840 Count
1769767278	40 Count	779 Count
1769764637	39 Count	757 Count
1769761997	38 Count	733 Count
1769759356	37 Count	700 Count
1769756715	36 Count	667 Count
1769755001	35 Count	667 Count
1769752361	34 Count	667 Count
1769749719	33 Count	661 Count
1769747079	32 Count	661 Count
1769744438	31 Count	661 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)