PenangAPRS Track

My position About ☰

reset

ON3RIP-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object ON3RIP-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*
1794329040	905 Count	22 Count
1794328137	890 Count	22 Count
1794327233	878 Count	22 Count
1794326330	862 Count	22 Count
1794325426	850 Count	22 Count
1794324603	833 Count	22 Count
1794323700	816 Count	22 Count
1794322797	797 Count	22 Count
1794321893	780 Count	22 Count
1794320990	764 Count	22 Count
1794320086	747 Count	22 Count
1794319183	717 Count	22 Count
1794318280	700 Count	22 Count
1794317376	682 Count	22 Count
1794316473	665 Count	20 Count
1794315570	648 Count	4 Count
1794314667	630 Count	4 Count
1794313763	614 Count	4 Count
1794312860	597 Count	4 Count
1794311957	578 Count	4 Count
1794311054	551 Count	4 Count
1794310150	533 Count	4 Count
1794309247	518 Count	1 Count
1794308343	500 Count	0 Count
1794307439	483 Count	0 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)